Cisco SF 100-16 Kurzanleitung Seite 7

frame to the switch, blocking the high-priority QoS packets
queued on the port. On some devices, such as some IP phones
and IP cameras, flow control might not be configurable.
Connect the power cord to the switch and a power source.
S 4
TEP
3
Features of the Unmanaged
Rackmount Switch
This section describes the exterior of the unmanaged rackmount switches
that provide non-blocking, wire-speed switching for your network clients.
Front Panel Ports
The ports and LEDs are located on the front panel of the switch.
RJ-45 Ethernet Ports —Use these ports to connect network devices, such
as computers, printers, and access points, to the switch. The auto-sensing,
Ethernet (802.3) ports are used for wired network communications. Each
Ethernet port supports network speeds of 10 Mbps, 100 Mbps, or
1000 Mbps.
MiniGBIC (if present)—The miniGBIC (gigabit interface converter) ports are
connection points for miniGBIC modules, so the unmanaged rackmount
switch can uplink to other switches by using optical fiber.
• MiniGBIC ports are compatible with Cisco miniGBIC modules MGBSX1,
MGBLH1, MGBT1, MGBLX1, and MGBBX1, as well as other brands of
miniGBIC modules.
• MiniGBIC interface is a combination port, shared with one other RJ-45
interface. When the MiniGBIC is active, the closest RJ-45 port is
disabled.
• The LEDs on RJ-45 respond to the miniGBIC interface traffic.
6
1 13 2 14 3 15 4 16
LINK
ACT
5 17 6 18 7 19 8 20
GIGABIT
Cisco Unmanaged Rackmount Switches
9 21 10 22 11 23 12 24