Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MSR501
1.
Shaving head
2.
Housing of the shaving heads
3.
Button used to open the housing
of the shaving heads
4.
On/Off button
5.
Display
CHARGING THE APPLIANCE
If the appliance's battery charge is low or the battery is totally discharged, it needs charging. Insert the
power supply cord into the appliance and connect the power supply unit to the electrical grid.
The charging indicator of the appliance will then display its charging status. If the appliance is totally
discharged, the indication of its charging status may be delayed. This delay should be no longer than 2
minutes.
Having connected the appliance to the charger, you may continue using the appliance. However, do
not use the appliance in the vicinity of baths, showers, swimming pools or similar water tanks.
SHAVER OPERATION
Switch the shaver on with the On/Off button.
Move the shaver across the skin surface, making circular movements.
Clean the shaving head after each use with the provided brush.
The appliance may be used for wet or dry shaving. If you use shaving foam or gel, rinse the shaver
regularly under a stream of tap water to prevent the shaving head from "clogging".
Note: Each shaver requires the skin and hair growth to adjust to the blade system applied. The first
shaves may not be perfectly accurate and the skin may be irritated. The adjustment period may last up
to 3 weeks.
SHAVER CLEANING
Make sure the appliance is switched off and not connected to the charger.
Clean the shaving film and the shaver blades after each use of the shaver. Use the brush for this
purpose. The blades may be rinsed under running water.
Clean the appliance regularly with due care. Press the button opening the housing of the shaving
heads. Remove all hair from the inside. Turn the ring mounting the blade heads to the left. Remove the
ring. Remove and clean each head and set of blades.
Note: place the blades in the heads they have been removed from (each blade is assigned to a
respective head, and if used in another head, the blade may be less effective or even get damaged).
Having cleaned the heads, place them in the housing along with the blades (pay attention to the cuts
and grooves), insert the mounting ring and close it by turning it to the right.
GROWTH TRIMMING (TRIMMER)
Switch the shaver off. Move the trimmer lock down. The blade of the trimmer will then push out. Switch
the shaver on and trim the hair. Switch the shaver off. To hide the trimmer, push it back into place on
the shaver.
6.
Trimmer
7.
Trimmer lock
8.
Socket
9.
Charging station
10.
Power cord with a adaptor (may be
connected both directly to the shaver and to
the charging station)
4
Werbung
