JJC TM Series Bedienungsanleitung Seite 9

l
Setting and starting drive modes except BULB
The following settings of camera and TM remote are required as follows:
CAMERA
TM
*When using autofocus, please choose an interval at least two seconds longer than the
camera shutter speed to leave the camera enough time to focus. When using long
exposure noise reduction, choose an interval time at least double the camera shutter
speed.
Ending Shooting
Shooting ends automatically when the selected number of shots has been taken. To end
shooting before all photographs have been taken, press the START/STOP button.
Used as a shutter release cable
After attaching the TM to a camera, turn on your camera and TM. As shown below, press
half to focus, and fully to take a photo. When the shutter speed is adjusted to BULB,
pushing the shutter button of TM in the direction of the arrow will lock the camera shutter.
Push the shutter button in the opposite direction, and the camera shutter will be unlocked.
Compatibility List
CANON
PANASONIC
FUJIFILM
TM-A replaces CANON RS-80N3 / TC-80N3
TM-B replaces NIKON MC-30 / MC-36
TM-C replaces CANON RS-60E3 / PENTAX CS-205
TM-D replaces PANASONIC DMW-RSL1
TM-F replaces MINOLTA RC-1000S/L / RM-S1AM / RM-S1LM
TM-G replaces NIKON MC-DC1
TM-M replaces NIKON MC-DC2
TM-J replaces OLYMPUS RM-UC1
利用 pdfFactory Pro 测试版本创建的PDF文档
Exposure mode M (manual) or S (shutter-priority auto)
Shutter speed Excluding BULB
Drive mode S (single shooting)
Delay Any number within the support range of the remote
Exposure time 0 s
Interval time Longer than camera shutter speed
Number of shots Any number within the support range of the remote
Speaker ON/OFF
NIKON
SIGMA
KODAK
PENTAX SAMSUNG
LEICA MINOLTA
www.pdffactory.com
OLYMPUS
SONY