JJC TM Series Bedienungsanleitung Seite 7

NOTE:
The remote has a default setting: Interval time (INT) = exposure time (BU) + time
from the moment this shot ends to the moment next shot starts. So when taking
long exposure pictures, to make the camera have enough time to focus, interval
time (INT) should be at least 2 seconds longer than exposure time (BU). When using
autofocus function, make sure delay/self timer is 2 seconds or longer to leave the
camera enough time to focus. When using long exposure noise reduction, the
interval should be at least twice the exposure time.
When interval time set is shorter than exposure time, then the settings will be invalid. To
ensure the timer is finished, the interval will automatically be reset to 1 second. According
to the system's default setting, the interval time is at least one second.
Number of shots can be set to any number between 1 to 399 or unlimited. To set the
number of shots to - - (unlimited), select 1 and then press the ▼ button or select 399 and
then press ▲ button.
After finishing adjusting all settings, press the SET button to put the new settings ENABLE.
A beep will sound (If the speaker is ON) and the "SET" icon indicator will go out.
Starting or ending the timer
Starting the timer
l
Setting and starting the BULB Mode
Camera Setting
Before starting the this function, camera settings are required to be adjusted as follows:
Exposure Mode M (manual)
Shutter Speed BULB
Drive Mode S (single shooting)
TM Setting
Please set your desired "DE", "BU", "INT", "N" and speaker status as described in
previous sections.
When finished all the settings, press the START/STOP button to start the timer. Now the
LCD screen will display countdown of delay (if delay≥1s) and then displays alternatively
countdown of the exposure time and time remaining before next shot begins.
During BULB shooting, the LCD screen shows the time remaining until the shutter closes,
利用 pdfFactory Pro 测试版本创建的PDF文档 www.pdffactory.com