JJC TM Series Bedienungsanleitung Seite 5

Delay/Self
DE
BULB/Long
BU
Exposure
INT Interval Timer
Number of
N
Exposures
Speaker
l
LED light/ Lock button
Press the button momentarily to turn on or turn off the backlight.
Press and hold the button for about 2 seconds to lock or release the following buttons:
start/stop button, arrow button and set button
l
START/STOP Button
Press this button to start or stop the timer.
l
Arrow Button and SET Button
Use arrow button to set the timer. Press ◄ or ► to select an item, ▲ or ▼ to adjust an
item. The current selection is indicated by the selection cursor.
Press the SET button to begin editing or save the current setting. To view other settings,
press the left or right arrow button. And the selection cursor will move and indicate the
current setting.
The following are setting steps:
利用 pdfFactory Pro 测试版本创建的PDF文档
Just like the self timer on your camera, the TM
remote allows you to set any delay (in 1
Timer second increments) up to 99 hours, 99
minutes and 99 seconds.
It allows you to take exposures up to 99 hours,
99 minutes and 99 seconds in length.
The Interval Timer can be set to any time
period up to 99 hours, 99 minutes and 99
seconds as well. For example, If you set it to
10 minutes, one exposure will be taken every
10 minutes until either the film runs out or the
Exposure Count limit has been reached.
This setting permits you to set the number of
exposures that will be taken, up to 399 shots.
Speaker ON/OFF
1. (DE) Delay/Self Timer (Time until shooting starts)
Hours
2. (BU) BULB/Long Exposure (Exposure Time)
Minutes
www.pdffactory.com
0s to 99hrs 59min 59s
0s to 99hrs 59min 59s
1s to 99hrs 59min 59s
1 shot to 399 shots or
unlimited
ON/OFF
Seconds