TimeLine strymon Bedienungsanleitung Seite 22

TimeLine
- Bedienungsanleitung
Globals Menu
EXP input mode:
Dry Signal:
Spillover:
Preset Names:
Preset Dump:
MIDI Clock Sweep:
MIDI Clock Reset:
Confi gures the EXP input to use an Expression Pedal or an external TAP footswitch.
PEDAL
TAP
Turns the dry signal on or off. This is sometimes useful in a parallel effects loop
when an effect level is necessary.
NORMAL
KILL - dry signal is muted allowing the MIX control to be used as an effect level
Allows the wet delay signal of a currently selected preset to "spill" into the
next selected preset. IMPORTANT: Because of the delay buffer architecture,
the current preset must be active for at least 5 seconds before spillover will be
operational.
OFF
ON
Enables or disables the display of preset names when displaying the current
bank. If set to ON or SCROLL, when incrementing through banks with the VALUE
encoder, the bank number will be displayed with 2 digits followed by the fi rst 3
characters of the preset name.
OFF
- bank numbers are displayed instead of preset names
ON
- the fi rst 6 characters of the preset name are displayed
SCROLL - the preset name will scroll once completely through it's 16 characters
then settle on the fi rst 6 characters
Allows presets to be sent via MIDI to another TimeLine or to a MIDI recorder
device. Presets can be dumped individually or all at one time. Select ALL to
dump all presets, or scroll to select an individual preset to send. Initiate send by
pressing VALUE encoder.
EXIT
ALL
PR 0A - 99C
Allows the option to keep or remove delay pitch artifacts when changing TAP
tempo from an external MIDI clock source.
ON
OFF
Allows the option to re-sync delay time back to an external MIDI clock source
tempo after tapping in a new tempo or sweeping the time knob on TimeLine.
ON
OFF
®
pg 22