Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TimeLine
- Bedienungsanleitung
Looper
TAP LED will turn
red to indicate looper
controls are active
and blink green to
show delay time.
TAP
BANK UP
STOP
hold (looper)
hold the TAP
footswitch to enter the
looper
TIPS & TRICKS:
Reverse, Half Speed, Undo (to initial recorded loop) and Redo.
NOTE: The loop can be played in the background if desired. Normally the loop will stop when exiting the looper. To
keep playing the loop when exiting looper set the Looper Exit global to PLAY. The looper can also be controlled via
MIDI at all times.
LOOPER GLOBALS: There are controls to vary the loop level, looper exit behavior and looper pre or post
confi guration in the GLOBALS menu. Please consult the globals section of the manual for more information.
LOOPER MIDI CONTROL: Controlling the looper via MIDI is accomplished by sending MIDI note numbers with a
velocity greater than zero OR MIDI CCs. Record, Play, Stop, Reverse, Half Speed, Undo (to initial recorded loo) and
Redo can all be controlled via MIDI. See the MIDI specifi cation for the note numbers and CCs.
A
A
REC / DUB
REC / DUB
A
A
BANK DOWN
A
REC / DUB
REC / DUB
push the A footswitch
to start recording
REC / DUB
A
BANK DOWN
REC / DUB
Connect an external MIDI controll to access additional looper features like
B
B
The A LED will
turn amber to
indicate looper is
PLAY
PLAY
overdubbing
®
®
B
B
A
BANK DOWN
BANK UP
B
PLAY
PLAY
REC / DUB
push the A footswitch
again to overdub
PLAY
A
OR
®
BANK DOWN
B
REC / DUB
BANK UP
PLAY
push the B footswitch to
play the loop. Any time the
B footswitch is pressed it
will re-trigger the loop.
TAP
TAP
B
BANK UP
STOP
STOP
hold (looper)
PLAY
hold (looper)
push the TAP
®
footswitch to stop loop.
or
hold the TAP
B
footswitch to exit
BANK UP
TAP
PLAY
STOP
hold (looper)
®
TAP
STOP
hold (looper)
pg 20
Werbung
Inhaltsverzeichnis
