Olsson e-scooter STROOT B8 Bedienungsanleitung Seite 18

The e-scooter incorporates a sensor, which when the speed decreases, either by
braking, or by climbing a slope (reduces speed), the electric thrust is deactivated,
moving to manual mode (foot). If you want to be helped again by your engine in
the push, redo the previous steps.
1. Press the ignition switch located under the scooter's platform and turn it on. It
has a sound warning that warns of the status of the battery, with the following
meaning:
A single beep, identifies that the battery is between a range of 100% of the load
up to 20%
A continuous beep, identifies that the scooter is below a load level of 20% and
that it needs to be charged.
2. Hold the handlebar with both hands, place one foot on the pedal and push the
other foot back to achieve acceleration. It will go to a low level (up to 9km / h,
depending on the weight and condition of the soil).
3. If you need to continue accelerating, repeat step 2. You will go to the high
level.
4. To decrease the speed, press the brake plate of the rear wheel with one foot.
When the speed of the scooter decreases to the desired speed, leaving to press
on the rear brake and the speed is still higher than 4 km / H, the scooter will
continue to operate at the previous speed.
When the scooter decelerates to a full stop or less than 4 km / h, the electric
motor is deactivated. If you need a new one, accelerate with the help of the
engine, repeat step 2.
The performance and parameters of the scooter may be subject to changes,
caused by variables, such as user weight, pending, activation-deactivation of the
engine in the thrust, pavement condition.
MORE INFORMATION AND SUPPORT
For more information on our products, practical advice, frequently asked
questions, user manuals, etc. visit:
www.olssonandbrothers.com
To contact our technical assistance service visit www.olssonandbrothers.com or
by Phone + 34 942 81 29 00
This product incorporates a lithium battery, so that in case of destruction, the