Olsson e-scooter STROOT B8 Bedienungsanleitung Seite 16

HOW TO DEPLOY THE SCOOTER
1.
5.
1. Install the foot stand using tools.
2. Press and hold the folding pedal (lower right) by hand and lift the handlebar
tube.
3. Lift the handlebar, and adjust the buckle (lower left) by turning it.
4. Close the front buckle to stabilize the handlebar (Second safety lock).
5. The handlebar support, has 2 handles, extend them and insert them on each
side, pressing the pivots until they enter the hole in the handlebar.
6. The handlebar must be inserted in the bar, adjusting the height depending on
the height of the user. It has 3 levels of height.
7. Lock the position by closing the hinge. Check that once closed, the handlebar
rotates the wheel. It is very important to verify that the adjustment has been
made.
Your new e-scooter should be assembled according to the previous steps,
as shown in the figure. Make sure you have completed all the steps during
assembly.
2.
6.
3.
7.
4.