Reset/Unsubscribe - Disty distyNotruf NEO Bedienungsanleitung

Reset/Unsubscribe

The settings configured by you can be reset to the original factory
settings. The emergency numbers that have been programmed
are not removed, however. The registration details of the base
station are deleted. This means you will have to reregister the
device with a base station before you can use it again.
Please complete the following steps to do this (the
distyNotruf
NEO
- Connect the distyNotruf
charging lead, the red LED will then shine and an acoustic
signal will ring out to confirm it is connected
- After 5 seconds at the latest, press and hold the alarm button
for 10 seconds – the green LED will start to shine
- Release the alarm button before the LED switches off again
(within 5 seconds)
- A tone can be heard and the red LED will start to shine
- Remove the distyNotruf
charging lead
- The distyNotruf
To reset your distyNotruf
"Programmier App" to do this.
Operating instructions
must be registered with the base station):
with the voltage-supplied
NEO
from the voltage-supplied
NEO
switches itself off
NEO
to factory adjustment, use the
NEO
EN
33