Configuring The Device Without The "Programmier App" (Pc) - Disty distyNotruf NEO Bedienungsanleitung

EN
Configuring the device without the
"Programmier App" (PC)
Subscription
Start the process on the base station of your normal DECT
telephone for registering a further mobile handset (see the
operating instructions of your base station).
Connect the charging lead to the distyNotruf and then
NEO
plug the cable into a power supply. Now press and hold the
button until the green LED starts to shine (10 seconds). Release
the button within 5 seconds. The green LED will now start
flashing, which means the distyNotruf is looking for a
NEO
base station that it can register with.
After successful registration, a loud acoustic signal will ring out.
This means the registration process has been completed.
"First incoming call" (only save the first emergency number)
– > voltage-supplied charging lead not plugged in
Ask the person (e. g. a family member, neighbour), who you
want to reach after pressing the button, to call you. Following
this the telephone number of the caller (CLIP) will be saved as
an emergency number after registration has been completed.
You will know that the emergency number has been saved
successfully when the distyNotruf ends the connection
NEO
as soon as the call has been accepted.
Operating instructions 31