Volume Adjustment - Hama DR7 Kurzanleitung

Warning – Batteries:
• When inserting batteries, note the correct polarity (+
and - markings) and insert the batteries accordingly.
Failure to do so could result in the batteries leaking
or exploding.
• Do not allow children to change batteries without
supervision.
• Do not mix old and new batteries or batteries of a
different type or make.
• Remove the batteries from products that are not
being used for an extended period
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not throw batteries in a fire.
• Keep batteries out of the reach of children.
4. Information and notes before getting started
Note – Optimal reception
Please note:
• Extend the antenna always completely.
• For best reception it´s recommended to extend the
antenna vertical.
• Try various different positions if necessary to get the
best reception.
5. Getting started
5.1 Battery operation
• Open the battery compartment cover. It is located on the
rear of the radio.
• Slide the battery compartment cover in the direction
indicated.
• Insert the batteries paying attention to the match the
polarities correctly. The correct polarity is indicated by the
plus and minus symbols in the battery compartment.
• Replace the battery compartment cover.
5.2 Mains operation
Connect the network cable to a properly installed and easily
accessible network socket.
The power supply unit is suitable for mains voltages
between 100 and 240 V, and is thus operable on almost
any AC power grid. Please note that a country-specific
adapter may be necessary.
You can find an appropriate selection of Hama products at
www.hama.com.
Note
• Only connect the product to a socket that has been
approved for the device.
• The electrical socket must always be easily accessible.
• When using a mult-socket power strip, make sure
that the sum power draw of all the connected devices
does not exceed its maximum throughput rating.
• If you will not be using the product for a ling period
of time, disconnect it from mains power.
5.3 General notes on use
Notes on use
• When a selection among menu items is to be made
(such as Y or N), the one currently selected flashes.
• In menus offering a variety of different options (such
as DRC, language and so on), the currently selected
option is marked with *.
Navigation and controls
[VOLUME/SELECT/NAVIGATE] (9) has two different
functions:
• Turn [VOLUME/SELECT/NAVIGATE] (9) to select among
menu items.
• Confirm the selection by pressing [VOLUME/SELECT/
NAVIGATE] (9).
Press [Back] (8) to return to the previous menu level.

Volume adjustment

Turn [VOLUME/SELECT/NAVIGATE] (9) to increase/reduce
the volume.
3