Grundig 6330 TA Bedienungsanleitung Seite 20

OPERATION ________________________________
Preparation
1 Remove all packaging and sticker materials and
dispose of them according to the applicable
local regulations.
2 Before using the appliance for the first time, clean
the appliance (See the "Cleaning and care"
section).
3 Make sure that the appliance is in an upright
position and on a stable, flat, clean, dry and non-
slip surface.
Note
When using the appliance for the first time,
7
smoke can develop due to production
residues. However, this does not mean the
appliance is defective. The first time you
switch it on use the appliance as you normally
would but without bread. It is recommended
to use the medium setting of the browning
control for heating. Ensure for proper room
F
ventilation.
Toasting
1
Insert only one slice of bread in each of the two
bread slots .
B
2 Connect the power plug into the wall socket.
3 Using the browning control
degree of browning between 1 and 6.
Notes
Pushing the browning control down to 1 will
7
give the lightest degree of browning and up
to 6 the darkest. The browning degree can
vary depending on the type of bread.
When toasting several slices of bread
7
consecutively, the toaster will become hotter
and therefore the bread will gradually
become darker. Therefore select an
appropriate browning degree. Let the toaster
cool down after each toasting process for
minimum 30 seconds.
The degree of browning of one slice is darker
7
than two slices, although the browning control
is set to the same level.
F
20 ENGLISH
select the desired
F
4 Press the start lever
B
snaps into place.
Notes
If the power plug is not connected into the
7
wall socket, the start lever
into place.
The degree of browning can also be adjusted
7
during the toasting process with the browning
control .
F
5 The appliance automatically switches off as
soon as the set degree of browning has been
reached.
– The toast slices are pushed upwards and can
be taken out of the toaster.
Notes
To cancel the toasting process before it has
7
finished, press the stop button
lever springs back up and the toast slices
B
can be taken out of the toaster.
Caution
Be very careful when taking the toast slices
7
out of the toaster as the metal parts of the
toaster and also the bread can become very
hot.
6
Disconnect the appliance from the wall socket.
If toast slices get stuck in the toaster, switch the
7
toaster off immediately by pressing the stop
button . Pull the power plug out of the wall
C
socket. Let the toaster cool down completely.
Carefully try to take the bread out of the
toaster without damaging the sensitive heating
elements and other parts. Do not use any
electroconductive objects to remove the bread
from the toaster.
down until it automatically
does not snap
B
. The start
C