EINHELL EGS 2600 Bedienungsanleitung Seite 11

Consumer Amperage
Halogen lamp
(HL 12-55,
4.5 A
Art. No. 10.955.00)
Car vacuum
cleaner 7 A
TV with satellite
receiver 4 A
Cool-box 4 A
12V immersion
pump 4.5 A
Check that the voltage and current ratings of the
consumer units will not overload the energy
station.
Overloading may destroy the energy station.
7. To operate the lamp
Proceed as follows to switch on the lamp:
¼
The lamp (Figure 1 / Item 6) is switched on and
off using the switch (Figure 1 / Item 7).
8. Starting aid for motor vehicles
¼
The charging cable with the pole clamps is
located on the side of the unit.
¼
When the jumper cables are not in use, do not
remove them from the energy station.
¼
Caution! Risk of short-circuiting if the pole
clamps touch each other.
¼
Use the energy station as a source of starting aid
only when the vehicle battery is partially
discharged. The energy station is designed
provide the car battery with only a limited
charge.
¼
The energy station is not suitable for starting
a vehicle with a fully discharged battery.
The energy station's starting aid function provides
welcome help when a vehicle's battery lacks
sufficient charge to start the vehicle without
difficulty.
Provisional We wish to point out that even standard vehicle
uninterrupted models are equipped with numerous electric
operation modules (e.g. ABS, ASC, fuel injection pump, on-
board computer and car phone). The higher starting
voltage and voltage peaks may cause damage to
electronic components. No product liability can be
4 h
accepted for any damage resulting from the energy
station's starting aid function. Please read the
information in the operating manuals of your vehicle,
2.5 h
radio, car phone, etc. Important! The energy station
has to be charged to full capacity in order to be able
to draw a current of 600 A for 5 seconds.
4.5 h
How to use the energy station to start a vehicle
4.5 h
1. Connect the red cable (+) of the energy station
2. Connect the black cable (-) of the energy station
4 h
3. The switch (Figure 1 / Item 1) must be set to
4. Turn the ignition key over to start position and
5. With the energy station connected, you can now
6. First disconnect the pole clamp from the
7. Then disconnect the jumper cable from the
8. The energy station will need to be recharged
9. Battery status monitoring
The voltage meter (Fig. 1/Item 5) keeps you
constantly informed as to the charge status of the
battery.
The red LED (Figure 1 / Item 4) lights up as soon as
you start to charge the energy station.
¼
¼
¼
to the POSITIVE pole (+) of the vehicle battery.
to the vehicle's earthing strip or any other bare
point on the engine block (earth). Choose a point
as far away as possible from the battery in order
to prevent ignition of any explosive electrolytic
gas which may develop.
„ON" position.
wait approx. 2 minutes.
DO NOT START THE ENGINE!
try to start the engine. Do not attempt to start
the vehicle for longer than 5 seconds because of
the very high current involved.
vehicle's earthing strip (negative pole).
POSITIVE pole (+) of the vehicle battery.
after giving this starting aid.
Green
The battery is 50 - 100 % full.
Yellow
The battery is 0 - 50 % full and should be
recharged.
Red
The battery is completely run down. The battery
can reach this state after jump starting a vehicle,
GB
11