Pin Assignment - Cleco mPro400GCD-P Bedienungsanleitung

P2300HW
2018-03
5

Pin assignment

All connections are short-circuit proof.
X5, X6 – Serial port for additional devices
• All outputs provide RS232 conforming signals.
• The inputs allow voltages in the range from -15 V to
+15 V.
- Voltages < 0.8 V correspond to a zero.
- Voltages > 2.4 V are interpreted as a one.
- Open inputs are preset to zero using a pulldown
resistor.
• The power supply pins are connected directly to the
main board power supply.
Do not connect or disconnect any

ATTENTION!
device during operation. Doing so
may result in a system reset.
Pin RS232-1 RS23-2
X5 X6
1 –
2 RxD RxD
3 TxD TxD
4 –
5 GND GND
6 –
7 RTS RTS
8 CTS CTS
9 –
X7, X8 – Anybus CC
Optional slots for Anybus CC modules,
X21 – TSnet system bus
Interface port for TSnet cable.
Pin Signal 8 pin M12 circular connector
1 Tx +
2 Tx -
3 Rx +
4 RX -
5 0 VDC
6 0 VDC
7 +24 VDC
8 +24 VDC
9 pin D-Sub male
with screw lock
–
–
–
–
X-coded
5
4
3
6
7
2
1
8
EN
X22 – ARCNET system bus
The station controller has an integrated bus termination;
therefore, no external termination is necessary.
Pin Signal
1 N.C.
2 DATA-B
3 GND
4 +5 VDC
5 DATA-A
6 N.C.
7 0 VDC
8 +24 VDC
X23 – Supply
Description
Connector with fuse holder
2-pin, 5 × 20 mm, 16 A slow-
blow
Use plug locking mechanism.
ATTEN-

TION!
See 6.3, "Connecting the controller to the
power source", Page 29.
X24 – Tool cable 30/50E×N... Series
Pin Signal
1-3 Power
4 PE (functional ground)
5 Tool bus
X25 – Tool cable 18/48E×E... Series
Pin Signal
1-3 Power
4 PE
5 Signals
X9, X10 – Input/Output
20
8 pin M12 circular connector
A-coded
5
4
3
2
8
Output (Sockel)
IEC connector C14
M23 circular connector
5
3
2
4
ECTA circular connector
Push-pull
1
4
2
5
6
7
1
1
3