Use; Care And Cleaning; Controls; Lighting - Electrolux EFT716X Gebrauchsanleitung

www.electrolux.com
6

2. USE

• The extractor hood has been de-
signed exclusively for domestic use
to eliminate kitchen smells.
• Never use the hood for purposes
other than for which it has been
designed.
• Never leave high naked flames un-
der the hood when it is in operation.
• Adjust the flame intensity to direct
it onto the bottom of the pan only,
making sure that it does not engulf
the sides.
• Deep fat fryers must be continuously
monitored during use: overheated
oil can burst into flames.

3. CARE AND CLEANING

- The Activated charcoal filter is
not washable and cannot be re-
generated, and must be replaced
approximately every 4 months of
operation, or more frequently for
particularly heavy usage (W).
- The Grease filters must be cleaned
every 2 months of operation, or
more frequently for particularly
heavy usage, and can be washed
in a dishwasher (Z).
- Control lights, if present.
• Clean the hood using a damp cloth
and a neutral liquid detergent.
W W
Z Z

4. CONTROLS

T1 T2
Button Function
T1 Turns the suction motor on
and off at speed one.
Press and hold the button
for approximately 5 seconds,
with all the loads turned off
(Motor and Lights), to turn
the Activated Charcoal Filter
alarm on/off.
T2 Decreases the working
speed.
When the filters alarm is trig-
gered, the alarm can be reset
by pressing and holding this
button for approximately 3
seconds. These indications are
only visible when the motor is
turned off.
T3 Increases the working
speed.
T4 Activates Power speed
from any other speed, inclu-
ding motor off. This speed is
set to operate for 6 minutes,
after which the system
returns to the speed that
was set before. Suitable to
deal with maximum levels
of cooking fumes.
L Turns the lighting system
on and off at maximum
intensity.

5. LIGHTING

• For replacement contact techni-
cal support ("To purchase contact
technical support").
T3 T4 L
Display
Displays the set
speed
- C flashes once , A.C.
Filter alarm Activated
- C flashes twice, A.C.
Filter alarm Deac-
tivated
Displays the set
speed
F indicates the
need to wash the
metal grease fil-
ters. The alarm is
triggered after the
Hood has been in
operation for 100
working hours.
C indicates the
need to change the
activated charcoal
filters, and also to
wash the metal
grease filters. The
alarm is triggered
after the Hood has
been in operation
for 200 working
hours.
Displays the set
speed
Displays P.