Troubleshooting - Inventum IVR0881S Gebrauchsanleitung

TIPS
• High ambient temperatures have a negative effect on energy use. Keep the refrigerator in a position away from direct sunlight or
other sources of heat.
• Keep ventilation openings free. Clogged openings lead to higher use of energy.
• Try not to open the door too often, especially when the weather is wet and hot. Once you open the door, mind to close it as soon as
possible.
• Turn the thermostat to a lower setting when the circumstances allow it.
• Before storing fresh cooked food, make sure the food has cooled at least to room temperature.
• Ice and frost layer increase energy consumption, so clean the appliance as soon as the layer is 3 to 5 mm thick.
• If the gasket is damaged or if it turns out that the sealing is poor, the energy consumption is substantially higher. To restore
efficiency, replace the gasket.
• Keep the condensor on the rear wall always clean, free of dust or any impurities.
• Always consider the instructions, otherwise the energyconsumption is substantially higher.
7

troubleshooting

If your appliance is not working properly, it may be a minor problem, therefore check the following:
Problem
Appliance is not functioning
Temperature inside the freezer is
too high or too low
Appliance is excessively noisy
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
20
• English
Cause
- Appliance is not plugged in
- There is a power failure
- The thermostat is set on ●
Thermostat has been set
incorrectly
Air circulation vents are blocked
Has the appliance been installed
correctly?
Are the pipes at the back touch-
ing or vibrating?
Solution
- Plug the appliance in
- Check the fuse box
- Set the thermostat on setting 1-5
Set the thermostat correctly
Clean the ventilation openings
Check the installation
Check it and move the appliance forwards