Wolf PRO ICBPW302418 Installationsanweisungen Seite 22

W O L F
I N S TA L L
W A L L H O O D S
To install light bulbs, insert bulb into recepta-
cle and rotate clockwise (bulbs not included).
Refer to the illustration below.
H O O D L I N E R S
To insert halogen bulbs, push bulb into recep-
tacle and rotate clockwise
included). Refer to the illustration below.
22
P R O V E N T I L AT I O N
L I G H T B U L B S
Halogen Lamp: 220-240 V 50/60 Hz, 50W
(maximum), GU 10
Heat Lamp (686 mm deep wall hoods
only): 220-240 V 50/60 Hz, 250W
(maximum), E27, R125 bulbs
1
/
Halogen Lamp: 220-240 V 50/60 Hz, 50W
(maximum), GU10 halogen bulbs
Light bulb installation — wall hoods
H O O D S
W O L F
W A L L H O O D S O N LY
The Wolf logo nameplate does not come
installed on the hood since there are various
locations that the nameplate can be attached.
Also, some customers prefer not to have a
nameplate on their hood.
A template for positioning the Wolf logo
nameplate in a standard location is included
on page 29. Follow these steps to install the
nameplate:
turn (bulbs not
4
Rotate Clockwise
N A M E P L AT E
Decide on the location for the nameplate.
Clean the mounting area with rubbing
alcohol.
If desired, cut out the template from page
29. Fold the template, locate placement on
hood and tape to the hood surface. Check
alignment and adjust if necessary.
Remove backing paper from the nameplate.
Position the nameplate in the template
cut-out and press into place.
Remove the template and any tape residue.
Push
Rotate Clockwise
Light bulb installation — hood liners
In