Wolf PRO ICBPW302418 Installationsanweisungen Seite 18

W O L F
H O O D L I N E R
S T E P 2 : W A L L P R E P A R A T I O N
18
P R O V E N T I L AT I O N
I N S TA L L AT I O N
Framing must be tied together and to
ceiling joists to provide enough structural
strength to support the weight of the hood
liner and internal blower, if applicable.
Construct the wood wall framing flush with
the wall studs and centered in the location
that the hood liner will be mounted.
Mounting holes for hood liners
H O O D S
51 70
mm mm
102
203 mm
mm
Refer to the illustrations below for the location
of mounting holes for Pro hood liners and a
cross-section of a typical installation.
If wall framing is not available, wall
anchors must be used.
#10 Screw
Hood Liner
#10 Screw
13 mm Drywall
Installation cross-section
Decorative
Hood