Installation - Klarstein 10029407 Anschluss- Und Anwendungshinweise

Installation

In general
When installing a heat pipe refrigerator, ventilation should be considered seriously, please refer to the
following:
• There should be left at least 200 cm³ for ventilation.
• The distance between wall and refrigerator side should be at least 20 mm.
• The bottom should be left at least 50 mm for air flowing air passing through must not be preheated.
• The entire cooling system should be considered in the ventilation.
• The following four pictures show four installation ways:
Changing the swing hinge
This refrigerator has the capability of the door opening from either the left or right side. The unit
is delivered to you with the door opening from the left side. Should you desire to reverse the
opening direction, please follow the below instructions:
• Pull out the three screws from right hinge.
• Remove the hinge (upper and lower) away.
• Install the door in suitable position with hinges, use three self-screws to fix them.
13