Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Working tips
ATTENTION: Always turn off electrical devices be-
fore using the digital goniometer.
Fig. 1
1. Put the goniometer flat on a reference surface, e.g.
a circular saw bench, a mitre-box saw or a planing
table. On a band saw the blade is the reference area.
2. Turn on the goniometer and press ZERO in order
to set it to 0.0°, calibrating the reference surface.
Fig. 2
3. Arrest the device on the blade or on the planning
arrester by using the integrated magnets (see fig. 2).
The goniometer should be held vertically to the table
for all measuring activities.
Fig. 3
4. Any correct adjusted blade, truing block or band
saw table is going to show 90°. If the display shows
any other result than 90°, re-adjust your appliance
according to the corresponding instructions of the
manufacturer.
www.scheppach.com service@scheppach.com +(49)-08223-4002-99 +(49)-08223-4002-58
Fig. 4
5. Replace the battery by turning the lid on the back
of the goniometer counter clockwise.
Maintenance
• Clean the goniometer with a mild cleaning agent
on a damp cloth. Never immerse the device into
water.
• Always use a 3V-battery.
• It is a sensitive precision tool and should be pro-
tected against excessive dust. Do not let the de-
vice drop.
GB
7
Werbung
Inhaltsverzeichnis
