Charging The Battery - LORCH MobilePower 1 Bedienungshandbuch

Messages, fault rectification
8 Messages, fault rectification
8.1 Welding operation
Charge condition indica-
tor (3)
Fault indicator (8)
8.2

Charging the battery

Charge condition indica-
tor (3)
Fault indicator (8)
06.15
Flash code
The first LED Welder not connected to the
flashes green/ battery
yellow alter-
nately
The first LED The battery is flat, further work-
flashes yellow ing is not possible
The first LED
Reserve operation: Continued
shows constant
working is possible
yellow
Continuous light Cell temperature too high
1x flash Over-current error on welder
2x flashes Cell temperature too low
3x flashes Cell over-voltage
4x flashes Cell under-voltage
5x flashes Error voltage at the casing
6x flashes Cell voltage differences
7x flashes Electronic fault
8x flashes
Flash code
The first LED
flashes green/
No charging current
yellow alter-
nately
Continuous light Cell temperature too high:
2x flashes Cell temperature too low
3x flashes Cell over-voltage
4x flashes Cell under-voltage
6x flashes Cell voltage differences
909.2099.9-02
Error
Connect battery to welder at the lat-
est within 15 seconds of button on
The battery needs charging
Charge the battery after 1-2 elec-
trodes
Allow the battery to cool down and
then operate at the correct operating
temperature
Replace the welder or consult the
service department
Operate in the correct range of
operating temperatures
Consult service department
Connect the battery to the charger or
consult service department
Consult service department
Consult service department
Consult service department
Error
Check the charger or consult the
service department
Allow the battery to cool down and
then operate at the correct operating
temperature
Operate in the correct range of
operating temperatures
Consult service department
Consult service department
Consult service department
Rectification
Rectification
- 15 -