LORCH MobilePower 1 Bedienungshandbuch Seite 14

7.2 Welding operation
 Isolate the charger from the battery.
 Connect the battery cable to the welder.
 Switch the MobilePower battery on using the On/Off
button (4). The button needs to be pushed for 3 sec-
onds when switching on/off, for safety reasons, until all
LEDs on the charge indicator come on. Then release
the button.
Observe the following:
i
First, connect the battery cable to the ma-
chine coupling on the welder and then switch
the MobilePower battery pack on.
Always switch the MobilePower battery pack
off before disconnecting the machine cou-
pling of the battery cable.
Never disconnect the battery cable when op-
erating the welding machine.
- 14 -
all LEDs light up green = maximum charge
Left LED lights up yellow = residual capacity will last for
another 1 - 2 electrodes
Left LED flashing yellow = the battery needs charging
7.3
‰ The button on the remote control (6) has the same
function as the on/off button (4) on the control panel.
 Switching on: Hold the button down for 3 seconds. The
green LED comes on to indicate readiness for opera-
tion.
 Switching off: Hold the button down for 3 seconds. The
LED goes out. The battery is switched off.
909.2099.9-02
Operation and display
Operating conditions
Welding with remote control
06.15