Troubleshooting - Blaupunkt RATK 750103 Bedienungsanleitung

To Store
Store it out of the reach of children, in a stable and safe position and in a dry place where the temperature is not too hot or too cold.
• Store the trimmer away from direct sunlight, if possible in a dark or barely lit place.
• Do not store in a nylon bag as this could encourage the formation of mould.
• Do not store the grass trimmer resting on the floor. Hang it by the upper handgrip instead, so that the guard does not touch
anything. The resting of the guard on a surface could alter its shape and therefore its dimensions and safety characteristics
would be modified.
To Clean
• Regular cleaning and maintenance of you grass trimmer will ensure effciency and prolong the life of your machine.
• After each cutting operation, take apart and clean out the grass and soil from; the spool and its slot, the whole trimmer and
in particular the guard.
• During operation, keep the air slots clean and free of grass.
• Only use a cloth soaked with hot water and a soft brush to clean the grass trimmer.
• Do not spray or wet the appliance with water.
• Do not use detergents or solvents as these could ruin the trimmer. The parts in plastic can easily be damaged by chemical
agents.
• If the wire cutting blade no longer cuts or breaks, have this replaced by contacting an authorised service center.
• Take special care to clean around the inside of cutting head guard, the cap and motor housing cooling vents.
• Refer to qualified service personnel if internal maintenance is required.
• CAUTION! The blade can give deep cuts.

TROUBLESHOOTING

PROBLEM
Line will not advance
when you restart the
machine.
Cutting head is hard to
turn
Grass wraps around the
attachment shaft and
the trimmer head
assembly
Liner trimmer stops and
will not start again
POSSIBLE CAUSE
1. Line is welded to itself.
2. Not enough line on spool.
3. Line is worn too short.
4. Line is tangled on spool.
Grass wrapped or built up around head.
Cutting tall grass at ground level.
1. Unit failed
2. Plug is damaged.
SOLUTION
1. Lubricate with a silicone spray.
2. Install more line (Refer to "Replacing the Cutting
Line" earlier in this manual).
3. Pull lines while alternately pressing down on
and releasing bump button.
4. Remove line from spool and rewind (Refer to
"Replacing the Cutting Line" earlier in this
manual).
Clean affected parts of the machine.
Cut tall grass from the top down.
1. Contact dealer to check damage
2. Check the plug