Maintenance; Device-Specific Safety Instructions - Blaupunkt RATK 750103 Bedienungsanleitung

•

MAINTENANCE

Before conducting any maintenance on the device, disconnect the mains plug.
Only those maintenance and fault elimination tasks described here may be carried out. Any other tasks must be completed by a
specialist. Only use original replacement parts. Only these replacement parts are designed and suitable for the device. Other
replacement parts will not only lead to an invalidation of the warranty, they may also endanger you and your environment.

DEVICE-SPECIFIC SAFETY INSTRUCTIONS

• Keep the handles dry and free of grease.
• Make sure to always wear personal protective clothing when operating.
• Make sure the connection cable is always kept out of the working range of the device. Make sure that cables always lead away
from the rear of the device.
• Make sure you are positioned firmly and with a natural stance when working with the device.
• Always hold the unit tightly with both hands.
• Before starting work, check the area for animal and objects. Remove all objects that may be blown away by the unit, or that
the thread may become caught on.
• Before starting work check the area and remove all objects which may damage the cutting mechanism.
• Always ensure sufficient distance to the cutting mechanism.
• In the vicinity of 15 m around the cutting area there should be no people or animal as they may be hurt by flying objects.
• Only work with good light and visibility.
• Do not work above hip height! Do not bend forwards or lean over backwards!
• The clothing of the operator should be close-fitting. Avoid wearing loosely fitting clothing. Wear sturdy footwear and long
work trousers.
• Pay attention when walking backwards. Danger of stumbling!
• The cutting tool will continue to rotate even after the engine has been switched off.
• Risk of injury caused by the cutting blades! After pulling out a new thread, always keep the machine in the normal working
position before switching on.
• Ensure that the ventilation slots are kept free from dirt.
• Never mount metal cutting elements.
• Children should be supervised to ensure that they do not play with the device.
• If the power cable of this device is damaged, it may only be replaced by the manufacturer, their customer service operation,
or a similarly qualified person,in order to prevent risks.
• Remember that moving parts may also be located behind ventilation and venting slots.
• Symbols affixed to your tools may not be removed or covered. Information on the device that is no longer legible must be
replaced immediately.
SYMBOLS
Disconnect the mains plug before all cleaning and maintenance work.
Read the operating manual before using the device
Be careful when handling the device! Observe all safety instructions in the instructions for use!