Troubleshooting; Technical Specification - Blaupunkt RATK 750104 Anleitung

TROUBLESHOOTING

PROBLEM
Line will not advance
when you restart the
machine
Cutting head is hard to
turn
Grass wraps around
the attachment shaft
and the trimmer head
assembly
Liner trimmer stops and
will not start again
Waste electrical products should not be disposed of together with household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling advice.
Separate collection of used products and packaging allow materials to be recycled and used again. Reuse of recycled
materials helps prevent environmental pollution and reduces the demand for raw material.

TECHNICAL SPECIFICATION

Voltage
Rated power
No load speed
Cutting line dia.
Cutting diameter
Line length
Net Weight
Vibration value:
POSSIBLE CAUSE
1. Line is welded to itself.
2. Not enough line on spool.
3. Line is worn too short.
4. Line is tangled on spool.
Grass wrapped or built up around head
Cutting tall grass at ground level.
1. Unit failed
2. Plug is damaged.
1. Lubricate with a silicone spray.
2. Install more line (Refer to "Replacing the Cutting
Line" earlier in this manual).
3. Pull lines while alternately pressing down on
and releasing bump button on side of spool
casing.
4. Remove line from spool and rewind (Refer to
"Replacing the Cutting Line" earlier in this
manual).
Clean affected parts of the machine
Cut tall grass from the top down.
1. Contact dealer to check damage
2. Check the plug
230V AC, 50Hz
550W
11000 rpm
1.5mm diameter
270mm
2 x 4.2m
2.5Kg
2.1 m/s2 K= 1.5m/s2
SOLUTION