Assembly / Operation - Hailo TP1 Gebrauchs- Und Bedienungsanleitung

5. Assembly / operation

The staircase platform can be individually adjusted and is
intended for use on straight and winding staircases.
The staircase platform can be adjusted to the different heights
and depths of steps:
with the help of adjustable support rails [C] in a vertical
direction and with likewise adjustable extension rails [E] in
a horizontal direction.
Setting up the staircase platform
1. Set the staircase platformg with the feet of both extension
rails [E-1] on a step and fold out the support frame [B].
The support frame locking mechanism [H] must engage
securely (see detail 1.1).
2. Using both locking bolts [D], unlock the support rails [C]
and pull out to the required length.
At the same time, check the horizontal position of the
platform on the level [G] (see detail 2.1).
Both support rails must then automatically engage
(see detail 2.2); the feet [C-1] must be supported
securely on the step.
3. If necessary, unlock one or both of the extension
rails [E] with the locking screw [F] and pull out to the
required length.
Then lock the support rails again (see detail 3.1); the feet
[C-1] must be supported securely on the step.
Before using, check the staircase platform to ensure a
secure horizontal position.
Setting up the hinged step / stepladder
4. Any HAILO hinged step with safety rail (min. 60 cm high)
or a HAILO stepladder with a maximum of 4 steps can be
set up in the middle on the staircase platform so the steps
can be climbed from above.
Climb the hinged step or stepladder only from above.
Storing the staircase platform
5. After using, slide both support [C] and extension [D]
rails back in and lock securely.
Unlock the staircase platform with both holds on the
support frame locking mechanism [H], fold together and
lock on the clip [A-1] on the bottom of the landing.
CAUTION! There is a risk of a hand injury when folding the
staircase platform; fingers can be pinched.
en
13