Koala Kare KB200-SS Montageanleitung Seite 5

INSTALLATION INSTRUCTIONS
Important:
In Step 3, SIX screws must be mounted
to the chassis to ensure proper load
bearing capacity! Use only screws and
hardware appropriate for the type of
wall where the baby changing station is
being mounted.
Step 3. Mount Bed and Chassis
Use only screws and hardware appropriate
for the type of wall where the baby
changing station is being mounted. Tighten
top two screws so that they are flush with
the wall. Use the four lower holes as a
guide to mark and drill pilot holes. Use
remaining four screws and four washers to
complete installation of bed and mounting
bracket. Insert washers over lower four
screws. All SIX screws and four washers
must be mounted to the chassis.
Step 4. Install Liner Dispenser
Ensure liner dispenser is free from
damage. Remove key, unlock, and open
liner dispenser lid. This will expose
liner dispenser mounting holes. Line
up dispenser mounting holes onto
chassis and secure with the four screws
provided. Close and lock the liner
dispenser door.
Step 5. Complete Installation
Inspect unit to ensure it opens and
closes smoothly. Clean gently with a
stainless steel cleaner, following the
manufacturer's recommended cleaning
instructions. Clean work area. Give
Operator Kit and key to the facility
operator. Replacement parts and
additional liners can be purchased from
your local distributor or by calling Koala
at 1.303.539.8300.
Before mounting this changing station,
ensure the wall surface where the unit
will be mounted can support a maximum
weight of 150 kg.
4