Tools Needed; Hardware Provided - Koala Kare KB200-SS Montageanleitung

OPERATING INSTRUCTIONS
Please Note:
To assure proper installation, it is suggested that a qualified person or carpenter install the Koala
Baby Changing Station. Koala Kare Products will not be responsible if the station is not installed
properly.
Koala Baby Changing Stations have been tested to hold a substantial static load. The unit must
be attached to a permanent wall that is capable of holding a substantial load.
Inspection Criteria:
A properly maintained baby changing station:
– Opens and closes smoothly
– Offers parents liners through a fully stocked liner dispenser. (Dispenser built into unit.)
– Provides a clean, convenient place for customers to attend to their children.
Measuring
Tape
Gloves
Drill
Use screws and bolts or
other hardware appropriate
to the type of the wall
and have it mounted by a
licensed professional.
1

TOOLS NEEDED

Phillips Head
Screwdriver
3 mm Drill Bit
(regular and
masonry)

HARDWARE PROVIDED

Four 8-32" x 5/16"
Flange Button-
Phillips Head
Screws
Level
5 mm Drill Bit
(regular and
masonry)
Four 1/4"
Flat
Washers
Stud
Finder
Pencil
12 mm Drill Bit
(regular and
masonry)