Networks And Connectivity; Connection To Supervision System; (External Supervisor System Solution) - Daikin FWECSA Installations- Und Bedienungsanleitung

FWECSA

NETWORKS AND CONNECTIVITY

CONNECTION TO SUPERVISION SYSTEM

(EXTERNAL SUPERVISOR SYSTEM
SOLUTION)
Connection is possible for version External
Supervisor System 3.10 or higher.
Using serial port RS485 it is possible to connect FWECSA
controllers (up to 247) to a management software that uses
standard MODBUS RTU as a communication protocol, with
the following characteristics:
• settable baudrate (defualt: 9600);
• no parity
• 8 bits of data
• 1 bit of stops
Inside a supervision network, each FWECSA controller acts
as a SLAVE towards the centralised management system
which constitutes the network MASTER (figure 01).
Once the network has been wired, it is necessary to configure
each FWECSA controller. Press PRG to access the MENU
and then enter sub-menu "Networks and connections"
(password = 20). Set the SETUP RS485 parameters as
follows:
• MST/SLV = "Slave from SPV"
• Protocol = "Modbus"
• Serial address = set a value between 1 and 255
• Speed = set based on the requirements of the Master
leave the SETUP OC PARAMETERS UNCHANGED (MST/SLV
= none).
For details on how to wire the network, read
"RS485 NETWORK GUIDE LINES" available in
the download area of the Daikin website.
The following functions are recognised and managed by the
FC66003946
Rev 00
Controller for units
USER MANUAL
It is strictly forbidden to reproduce this manual, even partially
controller as SLAVE:
CODE DESCRIPTION
01 coil status reading
02 input status reading
03 holding register reading
04 input register reading
15 multiple coil status writing
16 multiple holding register writing
The following are the available variables:
COIL STATUS (DIGITAL READING/WRITING)
DESCRIPTION
1 ON/OFF controller
2 SUMMER/WINTER controller
3 ECONOMY controller
4 ENABLE ANTI-FREEZE controller
5 ENABLE ELECTRICAL HEATER controller
6 modulating ventilation MAN/AUTO controller
7 enable ON/OFF from MASTER
8 enable ECONOMY from MASTER
9 enable SUMMER/WINTER from MASTER
10 enable ANTI-FREEZE from MASTER
11 enable ELECTRIC HEATERS from MASTER
12 enable SETPOINT from MASTER
13 enable SETPOINT LIMITS from MASTER
14 enable VENTILATION SPEED from MASTER
15 KEYBOARD LOCK controller
16 enable HUMIDITY CONTROL consent from MASTER
17 enable HUMIDITY CONTROL
18 control for CONFIGURABLE DIGITAL OUTPUT NO.7
EN
16