Care And Maintenance - Super-Ego SUPERTRONIC 2000 Bedienungsanleitung

ATTENTION! Fast speed must only be used to unscrew the head. Never thread on fast speed.
6.

Care and maintenance

Before carrying out any job on the machine, disconnect the plug from the mains outlet.
1. Cable and plug.
Both the cable and plug should be in optimum condition. Check them at regular intervals.
2. ON switch.
Check that the machine switch unblocks automatically when finger pressure is released. In case of any
anomaly, replace immediately with a new one.
3. Brushes.
Check frequently for brush wear and perfect contact with rotor. Change brushes when their length is 1/3
of original length. Use original SUPER-EGO brushes.
4. Motor and rotor.
he carbon dust accumulated in the motor and brush housing should be removed every 100 hours. The
motor's rotor should be permanently clean with a uniform surface (light bronze colour).
5. Threading heads.
Check that there are no damaged teeth on the head to be used, as thread quality could be seriously
deteriorated. Keep clean of swarf to achieve top quality threading and longer life.
6. Gear box.
Change grease every 500 operating hours. After dismounting the machine, oil all mechanisms to eliminate
old grease. Remove parts with dry compressed air and apply new grease with clean hands. Do not use
antdissolvents. Approximately 300 grs. of grease is needed for a correct lubrication. An excessive amount
of grease is not recommended as it can increase the temperature of the machine. Grease type: LGMT2
by SKF or similar. We recommend that this operation be carried out by an authorized after-sales service.
7. Dismounting the gear box.
Before dismounting the cover of the gear box, never introduce sharp objects such as tips, screwdrivers,
etc. between the body and cover's connecting faces. The correct procedure is to tap the front of the
octagon gently with a plastic hammer.
8. Tube fastener (clamp).
Check that the tube fastener clamp is in good condition. Replace when tube displacement occurs.
9. Machine maintenance and repair should be done by a specialist.
All repairs should be carried out by a specialist and only original parts should be used.
completely inserted. This will spring back securing the head.
To remove it, proceed in likewise manner.
6. Next insert the machine in the tube and make sure that
it is securely guided into its housing by the tube clamp bolt.
7. Check that the reverse gear lever is correctly in place
(arrow in working direction). Press the electric switch with
your right hand. Rotation will start immediately. Now
the head should be moved towards the tube to start the
threading process by pressing on the machine.
8. As soon as threading has begun, the head should be
constantly and abundantly lubricated with threading oil
SUPER-EGO.
9. Once the appropiate threading length has been achieved
(the tube of the threading head should never overhang in
a normal thread), stop the motor. Change the position of
the reverse gear lever and start the motor. The machine will
begin to unscrew the head and the tube will become free.
ENGLISH
11