XTZ EDGE SA-1 Bedienungsanleitung Seite 9

Low Pass
EQ
PARAMETRIC EQ
On / Off
PARAMETRIC EQ
Frequency
PARAMETRIC EQ
Gain
The low pass filter cuts away high frequencies at a certain point and over, the frequency point is set by the
crossover variable. We recommend that when using LFE signal to turn the low pass filter off, as most receivers
are handling filters internally.
This switch allows you to choose between the three different EQ settings.
REF, EQ1 & EQ 2 are explained in the "EQ" section, found on page 12.
At the "On" position the PEQ filter is active.
At the "Off" position the PEQ filter is bypassed and does not influence the signal in any way.
More info is found in the "PEQ" section, found at page 15.
The frequency potentiometer allows the user to fine trim the frequency area that need to be tuned.
The gain potentiometer allows the user to adjust the boost or decrease of the targeted frequency.
9