Protection Circuitry; Led Indicator - XTZ EDGE SA-1 Bedienungsanleitung

Your new subwoofer is equipped with special protection circuitry to provide maximum performance with
greatest reliability.
The protection circuitry prevents overheating and operates constantly without being audible. In some extreme
situations (e.g. sustained high output levels in warm environments), the unit may shut down momentarily.
This indicates operation of the thermal or over-current protection circuitry. If this should happen, turn the
Amplifier off with the main power switch, and let it rest for 10 min before you turn it back on. If the same issue
occurs again, please contact XTZ personnel.
WARNING: There is no protection circuit for longterm excessive volume use for some parts in the amplifier
Warning!
and speaker driver, in this case critical components may break due to sheer exhaustion.
Note: If clear audible distortion appears at high volumes, it is recommended to lower the volume.

LED Indicator

LED
Protect
* In the unlikely event that an over-current or over-temperature situation should occur, the Protection LED will
turn on and the amplifier will be in protect mode. Turn the Amplifier off with the main power switch, and let
it rest for 10 min before you turn it back on. If the same issue occurs again, please contact XTZ personnel.

Protection circuitry

Color Function
RED In protect mode*
25