Checking And Maintenance Instructions - Bestial Wolf Booster b12 Anleitung

CHECKING AND MAINTENANCE INSTRUCTIONS

A regular maintenance increases the security of the scooter.
Parts to check and make maintenance:
BEARINGS:
A fundamental part of the good working of the wheels is the bearings, situated between the axle and the
wheel. The good condition of these elements provides smooth and secure scooter movement..
The bearings are a mobile part subject to constant friction due to the scooter's use, so that it's logical
and normal its wear, causing loss of efficiency. To check its good working, hold the scooter and make
turn the wheels with a hand, the rotation has to be smooth, uniform, prolonged and without balancing,
otherwise if it wasn't so or any strange noise was heard, it could be a bearing deterioration or wear sign,
as a result it has to be replaced immediately by a new one.
We recommend you to apply lubricant to the bearings after using the scooter for some time. Those
lubricant or substitution actions with the bad condition bearings require a professional intervention
qualified for these tasks, as a result we recommend you to keep in contact with your dealer.
WHEELS:
The wheels are elements subject to a constant wear due to the scooter's use, as a result you should give
a special attention to its wear and its general good condition.
The good condition of the wheels affects the security of using the scooter regarding its adherence to the
surface or as a guarantee for a better work of the brake. Take a periodic look for both wheels and check
that its wear don't be excessive and don't have rips or deformations, in any of these cases or another
one that questions its correct efficiency, you should replace them immediately by a new ones, as a result
we recommend you to keep in contact with your dealer.
BEARINGS SEPARATORS / AXLES / AXLES SCREWS:
Those pieces are as well an important part of the mechanical set formed by the wheels and the bearings,
between both bearings introduced in the centre of the wheel there's a separator installed, and its mission
is to keep both bearings separated.
The axle from the back part of the deck goes through the bearings and the separator (and the axle has
usually two lateral pieces called bearing housing) or in the case of the front wheel the axle from the front
fork.
Those pieces are subject as well to a constant wear and possible damages caused by a bad scooter's
use, as a result you should revise them periodically and check the state of them, if you detect any
abnormality we recommend you to keep in contact immediately with your dealer.
14