Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
e-SCREEN ETX – QUICK START GUIDE
1. PRECAUTIONS
Caution: high risk, in order to prevent user from electric shock, please be careful when you insert the plug into the
socket.
Incorrect method of operation may result in electric shock or fire.
1. Before use, you must read and understand all instructions.
2. Keep manual for future needs.
3. Comply with all instructions during operation.
4. Do not use accessories the manufacturer does not recommend. Inappropriate nearby devices may cause accidents.
5. Do not exert pressure or tie the cord. Damaged power cord can cause electric shock or fire.
6. Do not attempt to repair the product, due to the high voltage inside the machine, devices and other components
may easily be damaged. When the product has a malfunction, the user must contact the supplier.
7. Please use accessories specified by the manufacturer or equivalent in terms of performance as the original parts
whenever replacing product parts. Improper accessories may cause a fire and risk of electric shock.
8. If the product needs to be wall mounted, please follow the manufacturer's recommended installation method.
9. Before cleaning the product, turn off and unplug it. Use a soft, slightly damp cloth to clean the product. Do not use
liquid cleaners or cleaning spray cleaners.
10. Please turn off and unplug whenever the product is not in use.
11. Please ensure air flow around the product, it can not be covered or blocked.
12. Please ensure to clean the covers on the infrared boards to avoid touch screen failure.
13. Do not place the product in direct sunlight or near heat sources such as radiators, heating equipment and other heat
sources.
2. ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your local authority or retailer for recycling advice.
3. TURNING THE SCREEN ON OR OFF
1. Plug the power cord into an AC Power outlet. Press Power Switch on the screen.
2. Now the screen is in standby mode. Wait briefly until the power indicator lights up, then press POWER
turn on the screen. (Be sure to wait for a few seconds before pressing POWER button. If you press the POWER
button too soon, the screen may not respond or may not work properly.)
3. Press
button again to turn off the screen and put the screen in standby mode.
To completely disconnect the power, press Power Switch on the screen.
Note: If the screen does not receive a displaying signal for a certain time, the screen will go into
standby mode.
4. THE FIRST TIME INSTALLATION
Connect to power source and turn on the screen, the installation menu page below will be displayed on the screen.
2
e-Screen ETX – QUICK START GUIDE – ENGLISH
Select desired menu
language, then press
START and go to
next page.
to
Select location and go
to next page.
15
16
14
8
9 1
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
