Cutout Delay - ABB Busch-Wächter Professional 220 EIB 6178 AGM-204-500 Betriebsanleitung

Cutout Delay

This will rule out, for instance, that the illumination in a
staircase is operated and switched on and off constantly.
The cutout delay can be set to any
value ranging between 10 seconds
and 32 minutes.
Note: When a new movement is detected within the
coverage zone while the set timer runs down the adjusted
time period starts anew if the dusk sensor has given an
enabling signal at this time.
If the time period is short and a strong infrared signal
prevails (eg during sunlight) minor cutout delay deviations
may occur.
GB
5
1
15
30
20
sek
32
10
min