Modster Trainee 600 Bedienungsanleitung Seite 20

Manual
Calibration of your Control System
1. Move the throttle stick to the minimum position
2. Turn on the transmitter and then the receiver
3. DO NOT unlock the gas
4. Hold the sticks as shown for several seconds
5. Once you hear a "beep" sound, it means the remote control
system is calibrated based on the horizontal level you hold it on.
7.2 Control Surface
20
To enable easy flying, the trainee is supplied with a pre-installed gyro. To turn on the gyro, slide the
stick to the "Anfänger" (Beginner) position. To turn the gyro off, slide the stick toward the "Experte"
(Expert) position. The center position allows a weaker gyroscopic effect.
ATTENTION: It is strongly recommended to turn on the gyro during the pilot's flight, especially when
flown by a beginner. Please note that the aircraft should be about 5-7 seconds in a quiet environment
before the gyro is turned on for the first time to allow calibration.
MODSTER Trainee 600
www.modster.at