Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BOOST in OFF position
U out
charger
U floating
0
I out
charger
I nom
0
3.3.5. Indicators
INDICATOR
Green "ON"
Yellow "Boost / Absorption"
Yellow "Floating"
These indicators are visible from the front of the appliance through the light guides, thereby allowing
operation of the appliance to be monitored.
4.
EQUIPMENT MAINTENANCE AND REPAIRS
4.1.
O
VERVIEW
This paragraph deals with equipment maintenance and repairs. Proper operation of the product and its
service life are dependent on strict compliance with the following recommendations.
4.2.
E
QUIPMENT MAINTENANCE
Disconnect the battery charger from the AC network before starting any maintenance work.
If appliances are in a dusty atmosphere, vacuum-clean them regularly, since dust deposits may adversely
affect heat release.
Check the state of battery charge every 3 months.
The tightness of nuts and screws should be checked annually to ensure efficient operation of the appliance
(particularly in hostile conditions: vibrations, shocks, high variations in temperature etc.).
A full technical inspection by a ENAG-accredited engineer is recommended every five years. It can also be
done at our plant.
With this setting, the CDS3 charger produces a single-stage UI
type load curve. It generates a constant voltage, supplying the
current required by the battery(ies). Recharging time depends on
the state of the battery, being longer than when the boost is in the
ON position.
t
t
STATE
On
Off
On
Flashing
Off
On
Off
- Charger is ON
- No or poor quality AC current
or
- Input fuse blown
or
- Internal charger malfunction
- SW1 Switch:
Boost in OFF position
or
- SW1 switch:
Boost in ON position and Boost/Absorption phase
completed
- SW1 Switch:
Boost
in
ON
Boost/Absorption phase
- Internal charger malfunction
- Output fuse blown
or
Charger current < 15% rated current (floating phase)
Charger current > 15% rated current
MEANING
position
and
charger
in
the
25
Werbung
Kapitel
