AEG X91384MDO Bedienungsanleitung Seite 10

HOOD OPTIONS IN SENSOR MODE
When operating in Sensor mode, the type
of hob being used has an influence. Two
options are available:
• Electric hob;
• Gas hob;
Initially it is set to electric hob. To change
the setting, proceed as follows:
• Turn the hood off using the hood on/
off button
• Press and hold the Sensor button for 8
seconds until the LED flashes as descri-
bed:
• 4 flashes indicate selection of the
electric hob;
• 2 flashes indicate selection of the
gas hob;
• Remove power for 10 seconds and then
reconnect it.
The calibration procedure is carried out
every time the type of hob is changed.
Calibration procedure: every time the
hood is turned on or the type of hob is
changed, the sensor calibration procedure
is run. During this time the hood must not
be used for cooking or subjected to parti-
cularly intense smells, for example solvents
or detergents.
This process requires:
• 13 minutes if the electric hob has been
selected;
• 1 minute if the gas hob has been selec-
ted;
This phase is marked by flashing of the
LED on the sensor button, if it has been
pressed.Do not turn the motor on during
calibration.
GB - HOOD OPTIONS IN SENSOR MODE / LIGHTING
Warning: Do not spray directly on the grill
cleaning products but only clean with a
cloth soaked in detergent. Avoid cleaning the
grill alcohol or silicone products.
Warning: This appliance is fitted with a
white LED lamp classed as 1M according to
EN 60825-1: 1994 + A1:2002 + A2:2001
standards; maximum optical power emitted
@439nm: 7µW. Do not look directly at the light
through optical devices (binoculars, magnifying
glasses...).
• For replacement contact technical support.
("To purchase contact technical support")
LIGHTING
10