Troubleshooting Guide - Chal-Tec 10007194 Bedienungsanleitung

B Python Adjustable Locking Cable (Not including in
this packing): See the Fig. 6
You can able to use a Python adjustable locking cable to
provide more security to your WildSpy Cam. The
"Master Lock" brand is a good choice.
With an optional choice, a steel mounting bracket and U type
security bar can be used to provide stronger
security ability. You can buy this accessory from your local
dealer.
CONNECT An Ext- Infra-Red Booster
For an experienced user, you always would expect to get extreme quality pictures and videos at night.
WildSpy Cam provide an option that up to 4 pcs external IR booster will be supported in a chain connection.
The "Ext-IR BOOSTER" port is found on the bottom of cabinet. You just plug one end from the booster
which is our WildSpot Flash series like IRX-800 to the port on the camera without any further setting
required. Thus, you will get about 2~4X higher illumination at night. For advanced user, it should be
available to work with a totally invisible black IR booster like IRX-20B or IRX-22B series to be upgraded
as an invisible black night vision camera
No animal showing in some pictures:
1. Check if the unit is pointed the direction where the sun is rising or sunset that the sensor might
be triggered.
2. The PIR sensor may detect an animals through vegetation out of view from the camera.
3. If the animal was moving quickly, camera may not capture it in time while an animal still
staying in the zone.
4. Make sure that the unit is mounted on a steady tree or other place that does not wobble.
The Camera In-Use light is remaining ON, but the camera does not respond:
1. The camera may be time-out and shut down automatically. Repeat to press the CAM-PW to
resume the camera ON.
2. Battery may be too low that could not support the camera staying ON. Replace with 4pcs D
type brand new batteries.
The CAM-PW switch does not respond:
Attempt to turn the camera too quickly after the main power ON. Wait for about 10 seconds until the back
light of scouting LCD goes to OFF. Then try again.
The Light in the front of the housing does remain ON:
1. The unit just is set for Walk-Test mode. The light remains On steady within 60s warming up period.
2. The CAM-PW is not OFF. Remember to turn camera OFF after finishing usage.
Camera seems NOT write any picture into my empty CF card and displayed with Memory Full:
1. You must format the CF card which was ever used in the other device before applying it in this
camera.
2. Check the current CF card and try to use 1G CF card instead of your current CF which may larger
than 2G or above. To use a large CF card over 1G, a specified brand may be required.
Reset the Unit out of System Halt:
In case the event counter stop to respond for any sensing, or you notice the LCD is always blank even the
Power switch is ON, the system may halt already to cause the problem. Remove all batteries out of
compartment for more than 10 minutes in order to reset the unit. All pictures will be retained and the unit
will resume to the factory default settings. You will need to reprogram with your desired parameters before
use.

Troubleshooting Guide