Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Using a CF card
This unit has built-in with 16Mb internal memory and therefore the camera can capture for some images or
videos immediately even no CF card in the slot. In fact, 1G CF card is recommended to increase more
storage capacity that allow more than a few thousands of pictures to be saved when you will leave it in the
field. If you have two CF cards and a card reader, it is very good for you that one could be left in the camera
and the other one at home for backing-up after viewing and downloading.
Note: Be sure the Main PW Switch is OFF before replacing for a CF card in order to minimize a
risk to damage your CF card or loss data partially.
Important: If a CF card can not be inserted smoothly, you must retract it and check if the
direction of card is correct or not. Never force to push hardly with the CF. Most of case with a
problem with card usage is found that caused by an improper insertion.
Warning: Before using a blank new CF card, or used in other cameras, it is suggested to format it before
usage.
Memory Management
In case either built-in or CF card memory is full, a memory FULL icon will be remaining blinking on the
scouting LCD. The camera will stop to shoot. Replace an empty CF card or delete some or all contents then
reboot the unit by the main Power switch to refresh the memory status. Make sure the memory FULL icon
disappear after PW up again. The camera will not resume to work without rebooting the system.
Installing Driver
The first time that you connect the camera to your computer, the computer will detect a new USB device
has been connected and try to looking for a driver. So that, it is required to run the attached CD-Rom before
connecting the camera to PC. Follow the instructions to complete the driver and software installation. Since
the CD-Rom is inserted, an auto-run will show a pop up installation menu. If your computer does not run the
setup program automatically, please run "SETUP" file under root directory of the CD-Rom. Then, click the
DRIVER button on the pop up window. Follow the instruction until to complete itself.
Installing Photo Editing Software
There are two simple photo / video editing software for entry level user. You may skip this option and exit
directly if you already have other existing or better software for viewing the pictures or videos.
- Insert the installation CD. Click " Photo Express " Button on the Welcome Screen.
Choose the operation language which you need.
-
Install the software according to hints.
-
Restart your PC.
-
Downloading photos/ Movies to your computer
- Be sure the driver has been installed successfully. Press CAM-PW to turn the camera ON, then press
PREVIEW for Play-Back mode.
- Connect your computer and the camera with USB cable.
A pop up to show the mobile hard disk which is assigned for the trail monitor device For example:
-
"H" or "I":\DCIM\100MEDIA
Click into the proper directory to see all files inside.
-
Mounting Device
Before starting to put this camera in the field for scouting game, the
camera must be mounted in a certain place properly or on a tree
whose diameter will not be less than 6 inch (15cm) and located not
higher than 1M with your desired mounting method that following the
installation method as shown as below. The design is reserved to fit for
two ways of mounting.
A Belt Mount: This belt is attached in the packing. See the Fig.5
Werbung
Inhaltsverzeichnis
