Chal-Tec 10007194 Bedienungsanleitung Seite 14

Event Counter
Three digits in the center of the lower LCD are the event counter which let you know how many motion
records that up to 400 events for a trail history. If you want to renew the counter anytime, simply to press
and hold the OK/DEL button until LCD become blinking, then it will resume to [000].
Battery Icon
Three icons are for difference battery groups. The Bat-icon on the upper corner of right is represented for
motion sensor power. The second on the right is for camera power. The rest on the lower of right corner is
for IR flash power. All Bat-icons will indicate three status as below:
GOOD: Battery Icon show with solid.
LOW: Battery Icon is half blank.
BAD: Battery icon is totally blank.
Note: You have to replace all batteries for new one completely when either camera or IR
Flasher are BAD. Do not try to replace some of them only. But the motion sensor power is
independent to the camera power system.
Walk-Test / Sensitivity Adjustment
The DISTANCE dial on inner panel is used for adjusting sensitivity of the motion sensor. By turning the dial
to the right, sensor sensitivity is set to the Max to detect animal over 40 feet away. You may reduce the
detection distance for taking picture with a larger animal target. Walk-Test feature is used to verify the
detection range and pointing zone before placing it in the field. After hanged the unit on a tree, push the PW
switch to Walk-TEST. The Walk-Test LED will light up last 1 minute to warm up. A radar icon with TEST alert
is remaining blinking during Walk-Test mode. Then, Walk-Test Light will goes off and will alert with 3 times
flash once you will be detected in front of the device. Now you try to go far away to check how long the PIR
motion sensor will still see you. The camera does not take any picture during this test process.
Note: The system will resume to normal ON DUTY mode automatically after 3 minutes (Time-Out) since the
last triggered detection of walk-test to avoid user may forget to push the PW switch back to ON before left.
PW-ON Mode
This is main PW switch in the bottom of cabinet. Since the PW-SW is pushed to ON mode, the unit will begin
to warms up for 1 minute, then start to detect motion for taking pictures/ Video. When an animal or human
is detected, an event will be recorded and the camera will shot immediately. All the detected events will be
counted up to 400 events even the memory of Digital Camera may full.
OFF Mode
Slide the PW to the center position turn the system power OFF. All pictures and current settings will be
remained at this mode and internal real time clock will still run. Note: Remember to remove all batteries if
you will not use it for a long time
Walk-Test (LED+DC in-use Indicator)
Both lights will be ON during the first minute of starting Walk-Test mode and Camera setting mode. They
will blink for 3 times once a walk-test motion to be detected.
In the scouting setting mode, an instant flash is response to each valid key input.
Turbo Shot
There is switch knob on the right of the scouting LCD. Push the knob to Turbo mode, the DC will be set for
fast shooting. In this mode, capture speed will be 2x faster than setting in the BAT-Save while a motion is
detected. Setting of BAT_SAVE will ideal for extending battery life.