First Time Installation - Sharp HT-SB106 Bedienungsanleitung

6
3. VOL+/VOL- – Increase/decrease the
volume level.
4. PREVIOUS – Press to return to the
previous track.
5. – Press to temporarily pause a
playback. Press it again to resume the
playback. Hold down this button for
3 seconds to disconnect bluetooth.
6. EQUALIZER – press repeatedly to
switch among Music/Movie/News
equalizer modes. Music mode -
indicator light will fl ash once, Movie
mode - indicator light will fl ash twice,
News mode - indicator light will fl ash
three times.
7. MUTE – Press to temporarily switch
off the sound. Press it again to switch
it on.
8. BT – Press to enter to Bluetooth
mode. (Bluetooth mode - blue
indicator light)
9. NEXT – Press to skip to the next
track.
10. OPTICAL/ARC – Press to switch
between OPTICAL IN and HDMI
ARC mode.(OPTICAL mode - yellow
indicator light, HDMI ARC mode -
Cyan indicator)
RC OPERATIONS
Insert the battery into the remote control.
Point the remote control at the remote
sensor on the front panel. The remote
control works within a distance of about
8 metres from the sensor and within an
angle of about 30 degrees from the left
and right side.
BATTERY INSTALLATION
• Remove the battery compartment co-
ver on the back of the remote control.
• Insert one AAA/1.5V battery into the
battery compartment making sure that
the battery has been inserted with the
correct polarities matching the symbols
+, - as indicated inside the battery
compartment.
• Place the battery compartment cover
back onto the Remote control

First time installation

Placement and Mounting
A
A: Normal Placement
(Place Soundbar on leveled surface in
front of TV.)
B: Wall Mounting
Wall Mounting
NOTE:
– Installation must be carried out by
qualifi ed personnel only. Incorrect
assembly can result in severe personal
injury and property damage (if you
intend to install this product yourself,
you must check for installations such
as electrical wiring and plumbing that
may be buried inside the wall). It is the
installer's responsibility to verify that
the wall will safely support the total
load of the unit and wall brackets.
– Additional tools (not included) are
required for the installation.
– Do not overtighten screws.
– Keep this instruction manual for future
reference.
– Use an electronic stud fi nder to check
the wall type before drilling and
mounting.
B