Cleaning The Hepa Filter - Grundig VCC 7570 C Handbuch

CLEANING AND CARE ______________________
6
Then, remove the filter cover from the plastic
dust filter. The cover is under cyclone separator.
In order to remove turn it anti-clockwise and
push it down.
7
If necessary, cyclone saparator can be
removed by pushing down. All parts included
in plastic dust filter except cloth dust bin filter
are washable.
8
Place the cyclone saparator, filter cover and
cloth dust filter back on the plastic dust filter
after cleaning.
9
Place the dust container lid with the plastic
dust filter back into the dust container.
10
Make sure that the cyclone separator is po-
sitioned properly so that the notches on the
sides of it are lined up with the locking pins on
the dust container
11 Place the dust container
Caution
Dry the separator completely before replacing.
█
The cyclone separator should not be sub-
█
merged in water.
Never use detergents or boiling water to wash
█
the filters.
The dust container, including plastic dust filter
█
must be inserted before the appliance is started
as otherwise the motor will be damaged.
.
G
back into the unit.
G
Cleaning the HEPA filter
1 Turn the HEPA filter cover anticlockwise until the
arrow shows the unlocked symbol on the filter
cover and pull the cover out.
2 Take out the HEPA filter. The filter can be tapped
against the side of a dust bin for removal of the
excess dust.
3 Wash the HEPA filter in warm water (maximum
40ºC), rinse very well and leave to air dry.
Caution:
Never put the filter into the washing machine or
█
dry it with a hair dryer.
Ensure the filter is completely dry before putting
█
it back into the cleaner. Allow to air dry for 24
hours before replacing.
Do not use detergents or boiling water to wash
█
the filter.
The HEPA filter must be inserted before the ap-
█
pliance is started as otherwise the motor will
be damaged.
4 When the HEPA filter is completely dry, insert
it back into the appliance before restarting.
ENGLISH 21