Beper 40.991A Betriebsanleitung Seite 8

Nail Gel UV Lamp Use instructions
If you decide not to use the appliance any longer, make it unserviceable by simply cutting the supply
cable after disconnecting the plug from the socket. Also make any dangerous parts unserviceable,
especially for children who could play whit the appliance.
Let other potential users read these instructions.
Keep these instructions
INSTRUCTIONS FOR USE
This UV nail lamp has been manufactured only for household use and cannot be used be for indu-
strial or commercial use.
Do not try to open the UV nail lamp or any parts of it.
Never leave the appliance unattended as long as the power plug is connected with the power outlet.
Use only provided accessories.
A regular cleaning of this UV nail lamp will keep it intact as long as possible.
Do not use if the UV nail lamp is damaged; contact directly the provider or assistance centre.
DESCRIPTION Fig. 1
1. Lamp body in ABS plastic
2. 4 bulbs UV, 9W each
3. Cord supply
4. Switch on/off I/0, and "timer" II
5. Timer 120 seconds
6. Fuse
7. Mirror effect internal for a perfect drying
8. Slide base plate for plugging the bulbs
INSTRUCTION
Before use please read instructions carefully.
• While inserting or replacing the UV bulb the lamp has to be switched off and unplugged.
• Do not get into contact with water.
• If not in use, switch it off and disconnect from the power.
• To be used only for fingernail and toenail curing.
• Do not look straight into the illuminated bulbs.
• Note that over exposure to ultra violet radiation/UV lamps can cause skin or eye damage.
• Whenever you recognize a changing of the skin, seek medical advice.
• Children are not allowed to use the lamp without supervision of an adult.
• The lamp is for household indoor use only therefore never use it outdoor, that damages the quality
of the gel used.
• Malfunction has to be solved by an expert.
ATTENTION : only use professional gel ; the bad quality gel may burn nails with the UV light
of the appliance. In case of burns or if too hot, stop immediately. Put again the nails under
the UV light only when it is cold and for max. 120 secondes.
How to plug the bulbs in: Fig. 2
• Take the unit out of the box.
• Do not plug it in yet.
• Remove the slide base plate. 8