Operation - Olympia NC 620 Bedienungsanleitung

Ultraviolet (UV)
Faulty bank notes are detected by means of UV light.
CF1
appears in the display if faulty bank notes are de­
tected. Press the SET and + buttons to activate/
deactivate the function and set the sensitivity. If this
function is active, UV appears in the display.
Magnetic (MG)
This function detects magnetic ink on the bank notes.
CF2 appears in the display if faulty bank notes are de­
tected. Press the SET and + buttons to activate/
deactivate the function and set the sensitivity. If this
function is active, MG appears in the display.
Width (DD)
This function defines the width of the first bank note as
the reference width. The function is triggered when the
width of a bank note deviates by 3 to 5 mm, depending
on the accuracy setting.
The width of the first bank note is used as the refer­
ence.
Press the SET and + buttons to activate/deac­
tivate the function and set the sensitivity. If this function
is active, DD appears in the display.
This validation function is always active when the
value count and sorting functions are on. Strong
magnetic fields can affect the sensor and falsify results.
Doubled (DEN)
This function is triggered when the thickness of the
bank note is greater than 0.16 mm.
display if faulty bank notes are detected.
Press the SET and + buttons to activate/deac­
tivate the function and set the sensitivity. If this function
is active, DEN appears in the display.
Connected
This function is triggered when the reference width of
the bank note is exceeded by 1/3.
display if faulty bank notes are detected. This function is
always active.
Half
This function is triggered when the length of the bank
note is less than 70 mm.
faulty bank notes are detected.
This function is always active.
14
dE appears in the
EC
appears in the
EH
appears in the display if
Giu
Metallic strip (MT)
This function monitors the metallic strips in the bank
notes.
If this function is active, MT appears in the display.
This function is always active with the value count
function.
The SET and + buttons cannot be used to
change the function.

Operation

Switching the bank note counter on/off
The bank note counter is switched on and off using the
switch on the rear of the machine.
1
4
1 On
2 Off
After switching the machine on, it performs a self-test.
If the machine will not be used for a longer period,
disconnect it from the power outlet.
Self-test
After switching the machine on, it performs a self-test.
Switch the machine on.
5
If an error is detected, it is indicated in the display
(refer to "Error table" or "Self-diagnosis").
6
The machine is ready to operate.
2
Self-test is completed.