Operating Elements - Olympia NC 620 Bedienungsanleitung

Operating elements

1
REP/PRINT Display or print results of value count
1
MODE Select a function
2
CUR Select the currency
3
BAT Batch - stop the counting of bank notes
4
after a preset number have been counted
+ Increase the quantity preset for the Batch
5
function
SET Set the sensors/sensitivity
6
ADD Activate/Deactivate the Add function
7
MNL Activate/Deactivate the manual counting
8
function
SPEED Change the counting speed
9
RUN/C Start counting / Delete count results
10
11 Display (see 2)
Display
2
Display sections 1 - 6
1 The set currency
2 The set sensors and their sensitivity
3 The counting function is activated
4 The number counted
5 The Batch function is activated, batches of 100 are
counted
6 The counting speed is set to 1,000 bank notes per
minute
12
Functions
Value counting
This function enables bank notes of the same currency
but with different denominations to be counted in one
operation. In this case, the machine counts the total
value of all the bank notes and the number of bank
notes according to each specific denomination.
Before the counting process:
CUR
USd SEH
or
MODE until VALUE appears in the display [3].
After the counting process:
The number of bank notes counted appears in the dis­
play [4] and the total value (val) to the right.
REP/PRINT
bank note denominations are displayed.
8 seconds after the last button was pressed, the total
value reappears in the display.
REP/PRINT 3 sec.
vidual bank notes and the total value are printed out on a
printer.
To be able to print, a printer must be connected at
the RS-232 port.
Sorting
With this function, the first bank note is used as a refer­
ence for those following. If the machine detects a bank
note which deviates from the reference note, the ma­
chine stops.
ing bank note can be removed.
Only those bank notes which match the first note
are counted. The total value of bank notes counted
is also established.
Before the counting process:
CUR
USd SEH
or
MODE until SORT appears in the display [3].
After the counting process:
The display shows the total number of bank notes coun­
ted, the total value of the bank notes counted and the
value of the individual denominations.
REP/PRINT
value are printed out on a printer.
To be able to print, a printer must be connected at
the RS-232 port.
Giu
until the required currency (
) appears in the display [1].
The number of the corresponding
The quantities of the indi­
CF3 appears in the display [3]. The deviat­
until the required currency (
) appears in the display [1].
3 sec. The quantity and total
Eur tL GbP
, , ,
Eur tL GbP
, , ,