Wps; Router; Diagnostic Information - M-Life ML0670 Bedienungsanleitung

devices don't support WPA or WPA2.
WPA: A strong security standard, supported by most Wi-Fi devices. 8 to 63 ASCII
characters needed.
WPA2: A stronger, newer security standard. Limited to newer Wi-Fi devices. 8 to
63 ASCII characters needed.
Select an encryption mode in the list and set your password.
If you select "None", any Wi-Fi enabled device can connect to the device without the password.
4.8.2. WPS (Wi-Fi Protected Setup): set the method used for WPS.
WPS (Wi-Fi Protected Setup) provide a more intuitive way of wireless configuration between
your device and the wireless device. Please make sure that the device supports WPS.
• PIN:
1. On the device (eg PC), select the Wi-Fi access utility which includes WPS support
(provided by PC vendor) and select the PIN method, then a 8 digits PIN code will
be generated.
2. Login web page(192.168.43.1),settings->WPS.
3. Enable PIN and entered the 8 digits PIN code.
4. Click <Apply>
• Note: If the WPS function start correctly, the info will display in the page as bellow:
• "PIN submit successfully!", else displayed" PIN submit failed!" to indicate the problem
happened during the WPS setup.
4.8.3. Router: set the parameters related to router.
This page gives you the following status information:
• Router IP Address: The router's IP address on the LAN. The default setting is "192.168.43.1".
• Subnet Mask: The router's internal LAN subnet mask. The default setting is "255.255.255.0".
• DHCP Server: DHCP Server will automatically assign IP addresses to devices on the
network. The default setting is "Enable".
• DHCP IP Pool: Set a range of IP addresses available to access.
• DHCP Lease Time: Amount of time that a Wi-Fi enabled device can use its assigned
IP address before it is required to renew the lease.
4.8.4. Diagnostic: display the device info.

Diagnostic information:

Including Software Version, Hardware Version, Device Name, IMEI, MAC Address, IP
Owner's manual
- 37 -
EN