Sennheiser ASP 2 Bedienungsanleitung Seite 18

¿
ASP 2
»
ASP 2
µ ¾
EM 500 G2
´ ²
ASP 2
¸ ¹
EM 500 G2
18
Connecting the antennas
You can connect the following antenna types to the
º
antenna inputs
! two A 1031-U or A 2003-U passive antennas or
! two A 12 active antennas or
! a combination of passive antenna (A 1031-U or
A 2003-U) and antenna booster (AB 2).
Connecting the receivers
You can connect up to four rack-mount receivers (e.g.
EM 100 G2, EM 300 G2 or EM 500 G2) to the ASP 2. The split-
ter incorporates DC distribution for powering the receivers.
Pass the cables coming from the antenna spitter's DC out-
puts through the cable grips
vers.
Insert the hollow jack plugs into the sockets
vers.
Connect the BNC cables
the receivers as follows:
! Antenna outputs (OUT A)
! Antenna outputs (OUT B)
Note!
We recommend protecting unused RF outputs with a 50 Ω
terminator in order to keep to the specified distribution
attenuation.
and :
µ
at the rear of the recei-
and of the antenna splitter to
to antenna inputs (ANT I)
to antenna inputs (ANT II)
¾
of the recei-
¹
¸