Herunterladen
Teilen
Diese Seite drucken
Park Tool BBT-90.3 Anleitung
  1. Anleitungen
  2. Marken
  3. Park Tool Anleitungen
  4. Fahrradzubehör
  5. BBT-90.3
  6. Anleitung

Park Tool BBT-90.3 Anleitung

Vorschau ausblenden
1
2

Quicklinks

Diese Anleitung herunterladen
PARK TOOL CO.
5115 Hadley Ave. N., St. Paul, MN 55128 (USA) www.parktool.com
The Park Tool BBT-90.3 Press Fit Bottom Bracket Bearing Tool Set is designed for installation and removal of the bearings and bearing units used in BB90,
BB92, Shimano
Press-fit, SRAM
®
tool and two bushing, which are used in conjunction with a Park Tool Bearing Cup Press (HHP-2 or HHP-3) to press the bearings into the bottom bracket shell.
BEARING REMOVAL
1. Insert and pull removal tool through bearing or
bearing/sleeve unit until flared end of tool snaps
behind bearing or sleeve.
2. Strike tapered end cap with hammer to drive
bearing or bearing/sleeve unit from frame.
3. Repeat steps 1 and 2 on opposite side to remove
second bearing or bearing/sleeve unit.
BEARING INSTALLATION
1. Assemble installation bushings, bottom bracket
bearings, bottom bracket shell, and headset
press as shown.
2. Turn handle of bearing cup press, making sure
the bushings, bearings, and bottom bracket shell
stay aligned. Continue pressing until each bearing
bottoms against the stop (a snap ring or machined
stop) inside the bottom bracket shell.
10/18
BBT-90.3
BBT-90.3 Press Fit Bottom Bracket Bearing Tool Set
PressFit GXP
, Race Face
press fit and other press fit bottom bracket systems. The BBT-90.3 includes a bearing removal
®
®
®
1
1
Instructions / Instructions / Anleitung / Instrucciones
PARK TOOL® and the color BLUE are registered trademarks of Park Tool Co.
2
2
© 2018 Park Tool Co.
loading

Verwandte Anleitungen für Park Tool BBT-90.3

Inhaltszusammenfassung für Park Tool BBT-90.3

  • Seite 1 ® ® tool and two bushing, which are used in conjunction with a Park Tool Bearing Cup Press (HHP-2 or HHP-3) to press the bearings into the bottom bracket shell. BEARING REMOVAL 1. Insert and pull removal tool through bearing or bearing/sleeve unit until flared end of tool snaps behind bearing or sleeve.
  • Seite 2 BB90, BB92, Shimano Press-fit, SRAM PressFit roulements utilisés pour les BB90, BB92, Shimano anderen Innenlager-Systemen verwendet. Das GXP, y Race Face entre otros. El BBT-90.3 incluye Press-fit, SRAM PressFit GXP, Race Face press fit Montage-Set enthält einen Austreiber sowie un extractor de balero con dos bujes, que usados et d’autres systèmes de boitier Press Fit.